King Pin Fitting on the Sunnen Hone
Posted on 07. Feb, 2012 by Office Space Planning in office space planning
© 2012 Office Space Planning. All Rights Reserved.
Internet Marketing by ireally
Posted on 07. Feb, 2012 by Office Space Planning in office space planning
© 2012 Office Space Planning. All Rights Reserved.
Internet Marketing by ireally
theycallmeGIORGIO
07. Feb, 2012
hahaha..best part of video. 0:07
par4par72
07. Feb, 2012
I’m sorry, But did he just say that reaming it would vary by .002-.003 T.I.R?…He must be out of GD Mind!
watcbd
07. Feb, 2012
Wow, he can tell by feel. A human micrometer.
dashwood123
07. Feb, 2012
Good one, it is nice to see a job done properly.
nartfocker
07. Feb, 2012
Brings back some nightmares, John: 8 hrs a day on a Sunnen MBB-1650 (manual feed). At one point, I had that damm machine’s serial number memorized ……
jacktheripped
07. Feb, 2012
I hope he doesn’t plan to drive this car too much. Spindels are among the worse things to Chrome plate due to Hydrogen Embrittlement. Due to the stress that a spindle gets they break easily.
chickeneggs4u
07. Feb, 2012
My dad was a kingpin. He liked kingfish. King me. I learned something today,thanks John.
nolatoolguy
08. Feb, 2012
u sure are right…………..few cars use kingpins…….i was talkin to a mechinic about what u dont see used anymore an i like all the kingpins an he gos huh….
MrKhalio
08. Feb, 2012
nice job,but if there is any un balanced pressure by your hand u will get misalignment,why u using manual method ???
thanks
gst69man
08. Feb, 2012
very impressive machine shop
Congrats.
zapwatt
08. Feb, 2012
John, is that a Deltronic pin you were using to check the bore I.D ?
1SICKYJ
08. Feb, 2012
Kool thanks John great work as usual keep it up.
ls6guy
08. Feb, 2012
sweet great work
masterd151
08. Feb, 2012
haha nice face shot at the beginning.